BLACK-T shock absorber Type Stage3 for BMW RnineT / Racer / Pure 2013 - 2021

27 525,00 Kč

Dodávka z centrálního skladu = doručení v nejbližší periodické dodávce do ČR (jednou týdně) + následující den kurýrem GLS kdekoliv v ČR. Na pražském skladu máme tisíce výrobků ihned k dispozici pro zákazníky prodejny, takže pokud máme vše z vaší objednávky na pražském skladu, posíláme to ihned a nečekáme na dodávku z centrálního skladu. V takovém případě jen záleží, kdy vaší objednávku dostaneme a zpracujeme. Uzavírka kurýrních zásilek je každý den v 15h. Jakmile kurýr odjede tak se musí počkat na následující pracovní den.

Kód výrobku
01-042-5860-0
vč. 21% daně

More performance and comfort for your BMW RnineT / Racer / Pure with the Black-T shock absorber Type Stage3 . Wether you set off to ride through many curves or to have a nice tour with your friends, the great adjusting range allows you to get a better setting of balance and damping as you could with the standard components. The Stage3 emulsion shock absorber can be adjusted via a hand wheel that adjusts the hydraulic spring preload. to be adapted to the load of the big travel luggage. The finely adjusted damping allows you to fine-tune the bike for any road condition and intended use, regardless of motorways/fast roads, country roads, country lanes or a speedy, ambitious driving style. The new dimension of chassis for your BMW RnineT / Racer / Pure.

 

Facts at a glance:

- This shock absorber is configured and adjusted ready for use based on our experience with the BMW RnineT.

- The parameters are: vehicle weight / shock absorber pivot point / design constraints / test rides.

- As with all suspension solutions, the rear and front of the motorbike should be modified together.

- If only one component is changed, optimal handling will not be achieved.

 

Properties of the Black-T Stage3 shock absorber:

- The shock absorber housing is made of aluminium. This results in lowest possible weight.

- Fitted with special low-friction seals with integrated Teflon back-up ring for low wear and long durability of the shock absorber.

- Emulsion construction and finer responses of the shock absorber.

- Large 16 mm piston rod made of chromium-molybdenum steel for maximum stability and durability

- 46 mm damping piston with special Touratech setup.

- The suspension spacer is fitted with sturdy stainless steel bushings for the fastening screws. This gives the fastening screw a firm, backlash-free fit, even at highest loads.

- All assemblies and components are designed for intensive touring use.

- High End hydraulic preload via an easily accessible, well positioned hand wheel.

- Fully service-enabled. This allows permanent maximum ride dynamics.

 

Scope of delivery:

- Ready-to-mount shock absorber.

- General Operating License

- Mounting instructions / user manual

 

"Optional" also available with black exchange spring

 

The basic setup fitted here is designed for riders up to 100 kg aditional luggage. Modifications are possible for a heavier rider (more than 100 kg) and/or if the bike is usually ridden with a passenger / with luggage. In this case, we individually modify the shock absorber to meet your needs by fitting a spring with a higher spring rate. Please use our suspension check and send us the completed form.

f you have any further questions, we will be happy to advise you. Contact us.

 

Více informací
Touratech Copyright © 2021